基于流体动力学的轮胎磨损颗粒物捕集通道位置研究
PDF下载 (7155)董家楠,黄海波,常向东,张 涛,焦润楠.基于流体动力学的轮胎磨损颗粒物捕集通道位置研究[J].宁波大学学报(理工版),2020,33(4):49-54.DOI:
DONG Jianan,HUANG Haibo,CHANG Xiangdong,ZHANG Tao,JIAO Runnan.The positioning of the capture tunnel for tire wear particlesbased on fluid dynamics[J].Journal of Ningbo University(Natural Science & Engineering Edition),2020,33(4):49-54.DOI:
| Title: | The positioning of the capture tunnel for tire wear particlesbased on fluid dynamics |
| 作者: | 董家楠, 黄海波, 常向东, 张 涛, 焦润楠 |
| Author(s): | DONG Jianan, HUANG Haibo, CHANG Xiangdong, ZHANG Tao, JIAO Runnan |
| 关键词: | 轮胎磨损颗粒物; 捕集率; 捕集通道; 入口 |
| Keywords: | tire wear particle; capture ratio; capture tunnel; entrance |
| 分类号: | U461.1 |
| 文献标识码: | A |
| 摘要: | 轮胎磨损颗粒物是车辆非尾气排放颗粒物的重要组成部分, 对大气悬浮颗粒物的影响日益增大, 对其进行捕集可减少对生态环境的潜在威胁. 基于喷射法和R-R颗粒物粒径分布, 建立了轮胎磨损颗粒物-轮胎-车辆流体动力学多相流模型, 采用Realiable k-ε湍流模型模拟了汽车在不同行驶速度下轮胎与覆盖件之间的最大风压分布区域, 继而研究了15种磨损颗粒物捕集方案通道出入口位置与捕集率的关系. 结果表明: 轮胎磨损微小颗粒物在后轮处比在前轮处与壁面碰撞的数量多; 捕集率随捕集装置入口高度的增大而减小, 随出口与轮罩边缘距离的增大而增大; 出入口的动压压差越大, 捕集率越高; 当车速为60km?h-1时, 入口位置H=297mm, 出口位置L=600mm时, 捕集率最高, 达到56.32％; 入口位置H=297mm时颗粒物捕集率均超过40％, 出口位置L=600mm时颗粒物捕集率均超过35％. |
| Abstract: | Tire wear particles are the non-exhaust emission of vehicles, which have great potential threat to the ecological environment. In this paper tire wear particle-wheel-vehicle model was built based on both injection method and the R-R model for particles distribution. The maximum position of wind distribution between the tire and wheel covers was investigated utilizing reliable k-ε turbulence model. 15 kinds of capture cases for entrance and exit positions and their capture ratios were explored. The results show that the qualities of fine tire wear particles entering the gap between the rear wheels and tire covers are greater than that near the front wheels. The capture ratio increases with the lower entrance position and higher distance from the exit to the entrance. The capture ratio reaches maximum to 56.32％ when the entrance position is at H=297mm and exit position is at L=600mm. The capture ratio is beyond 40％ and 35％ when the entrance position is at H=297mm and exit position is at L=600mm, respectively. |
| 参考文献 /References: | [1] Yu L D, Wang G F, Zhang R J, et al. Characterization and source apportionment of PM2.5 in an urban environment in Beijing[J]. Aerosol and Air Quality Research, 2013, 13(2):574-583. [2] Thorpe A, Harrison R M. Sources and properties of non-exhaust particulate matter from road traffic: A review[J]. Science of the Total Environment, 2008, 400(1/2/3):270-282. [3] Harrison R M, Jones A M, Gietl J, et al. Estimation of the contributions of brake dust, tire wear, and resuspension to nonexhaust traffic particles derived from atmospheric measurements[J]. Environmental Science & Technology, 2012, 46(12):6523-6529. [4] Wulff A, Pischinger R. Determination of emission factors for tire wear particles up to 10 microns by tunnel measurements[C]//Proceedings of 8th International Symposium Transport and Air Pollution Including Cost 319 Final Conference, 1999:265-272. [5] Wik A, Dave G. Occurrence and effects of tire wear particles in the environment — A critical review and an initial risk assessment[J]. Environmental Pollution, 2009, 157(1):1-11. [6] Newman S E, Panter K L, Roll M J, et al. Growth and nutrition of geraniums grown in media developed from waste tire components[J]. HortScience, 1997, 32(4):674-676. [7] Gualtieri M, Mantecca P, Cetta F, et al. Organic compounds in tire particle induce reactive oxygen species and heat-shock proteins in the human alveolar cell line A549[J]. Environment International, 2008, 34(4):437-442. [8] Gualtieri M, Andrioletti M, Mantecca P, et al. Impact of tire debris on in vitro and in vivo systems[J]. Particle and Fibre Toxicology, 2005, 2(1):1-14. [9] Gualtieri M, Andrioletti M, Vismara C, et al. Toxicity of tire debris leachates[J]. Environment International, 2005, 31(5):723-730. [10] 岑可法, 樊建人. 煤粉颗粒在气流中的受力分析及其运动轨迹的研究[J]. 浙江大学学报(自然科学版), 1987, 21(6):1-11. [11] 薛志亮. 水平槽道冷态气固两相湍流边界层中颗粒分布及颗粒尾流特性的实验研究[D]. 杭州: 浙江大学, 2016. [12] Gérardin F, Gentric C, Midoux N. Particle dispersion in the near-wake of an isolated rotating wheel: Experimental and CFD study[J]. Journal of Aerosol Science, 2014, 76:56-71. [13] Albriet B, Sartelet K N, Lacour S, et al. Modelling aerosol number distributions from a vehicle exhaust with an aerosol CFD model[J]. Atmospheric Environment, 2010, 44(8):1126-1137. [14] 刘金朋, 黄海波, 李淑欣, 等. 轮胎磨损颗粒物形貌及产生机理的实验研究[J]. 摩擦学学报, 2017, 37(5):587-593. [15] 轩闪闪, 黄海波, 刘金朋, 等. 基于解析方法的轮胎磨损颗粒物运动轨迹分析[J]. 中国机械工程, 2017, 28(8):1002-1007. [16] 卢轩, 黄海波, 张涛, 等. 汽车轮胎磨损颗粒物扩散特性的数值模拟研究[J]. 宁波大学学报(理工版), 2019, 32(1):44-51. [17] 唐家鹏. ANSYS FLUENT 16.0超级学习手册[M]. 北京: 人民邮电出版社, 2016. [18] Marisa L K, Julie M P, Britt L M, et al. Physical and chemical characterization of tire-related particles: Comparison of particles generated using different methodologies[J]. Science of the Total Environment, 2010, 408(3):652-659. [19] 杨志刚, 沙潇, 贾青. 车轮宽度对轿车风阻的影响[J]. 同济大学学报(自然科学版), 2014, 42(11):1682-1732. |
| 备注/Memo: | 收稿日期: 2019－09－02. 宁波大学学报（理工版）网址: http://journallg.nbu.edu.cn/基金项目: 国家自然科学基金（51975300）.第一作者: 董家楠（1992－）, 男, 江苏南通人, 在读硕士研究生, 主要研究方向: 滚动体摩擦磨损. E-mail: 1364345314@qq.com*通信作者: 黄海波（1978－）, 男, 山东临沂人, 博士/教授, 主要研究方向: 滚动体摩擦磨损. E-mail: huanghaibo@nbu.edu.cn 宁波大学学报（理工版）网址：http://journallg.nbu.edu.cn/ |
