U型加劲板稳定极限承载力影响因素分析
PDF下载 (638)陈沁恺1,柳俊哲1*,王 飞2.U型加劲板稳定极限承载力影响因素分析[J].宁波大学学报(理工版),2018,31(6):74-80.DOI:
CHEN Qin-kai1,LIU Jun-zhe1*,WANG Fei2.Analysis of the influence factors of the stability ultimate bearing capacity of U-rib stiffened plate[J].Journal of Ningbo University(Natural Science & Engineering Edition),2018,31(6):74-80.DOI:
| Title: | Analysis of the influence factors of the stability ultimate bearing capacity of U-rib stiffened plate |
| 作者: | 陈沁恺1, 柳俊哲1*, 王 飞2 |
| Author(s): | CHEN Qin-kai1, LIU Jun-zhe1*, WANG Fei2 |
| 关键词: | U型加劲板; 稳定极限承载力; 初始几何缺陷; 焊接残余应力; 荷载偏心距 |
| Keywords: | U-rib stiffened plate; stability ultimate bearing capacity; initial geometric defect; welding residual stress; load eccentricity |
| 分类号: | U448.36 |
| 文献标识码: | A |
| 摘要: | 为研究U型加劲板稳定极限承载能力受初始几何缺陷、焊接残余应力以及荷载偏心距等因素的影响, 采用考虑几何与材料双重非线性的有限元模拟方法, 对各影响因素进行参数分析. 结果表明, U型加劲板的稳定极限承载能力受初始几何缺陷的影响明显, 而焊接残余应力对其影响较初始几何缺陷更为显著; 荷载偏心距对加劲板极限承载力影响明显, 极限承载力随偏心距的增加逐渐降低, 且偏向U肋一侧时的降低幅度更大. |
| Abstract: | In order to study the influence of the initial geometric defect, welding residual stress and load eccentricity on the stability ultimate bearing capacity of U-rib stiffened plate, the finite element simulation method is used to analyze the parameters of each influencing factor in this paper. The results show that the stability ultimate bearing capacity of U-rib stiffened plate is obviously affected by the initial geometric defect, and the welding residual stress is more significant than the initial geometric defect. The load eccentricity has significant influence on the ultimate bearing capacity of the stiffening plate, and the ultimate bearing capacity decreases with the increasing of eccentricity and it tends to decrease more in the side of the U-rib. |
| 参考文献 /References: | [1] 秦凤江, 狄谨, 周绪红, 等. 钢箱梁U型肋加劲板受压稳定极限承载力影响因素分析[J]. 长安大学学报(自然科学版), 2017, 37(1):58-66. [2] 赵秋, 杨明, 翟战胜, 等. 受压U肋加劲板局部稳定受力性能数值模拟[J]. 建筑科学与工程学报, 2017, 34(1): 32-40. [3] 张小华. 正交异性钢箱梁加劲板局部稳定理论研究[D].长沙: 湖南大学, 2010. [4] 张欣. 正交异性钢箱梁局部稳定性研究[D]. 长沙: 湖南大学, 2005. [5] 李立峰, 邵旭东, 易伟建, 等. 扁平钢箱梁局部稳定模型试验[J]. 中国公路学报, 2007, 20(3):60-65. [6] Chou C C, Uang C M, Seible F. Experimental evaluation of compressive behavior of orthotropic steel plates for the new San Francisco-Oakland Bay bridge[J]. Journal of Bridge Engineering, 2006, 11(2):140-150. [7] Paik J K, Seo J K. Nonlinear finite element method models for ultimate strength analysis of steel stiffened- plate structures under combined biaxial compression and lateral pressure actions-part Ⅱ: Stiffened panels[J]. Thin- Walled Structures, 2008, 47(8/9):1008-1017. [8] ENV 1993-2:1997. Design of steel structures: Eurocode 3 [S]. [9] GB50017-2003. 钢结构设计规范[S]. [10] 赵秋, 翟战胜, 郭智勇. U肋加劲板初始几何缺陷试验研究[J]. 结构工程, 2016, 32(1):147-153. [11] 赵秋, 翟战胜, 王捷, 等. 基于数值模拟方法的U肋加劲板初始几何缺陷研究[J]. 公路交通科技, 2016, 33(1): 64-69. [12] Masubuchi K. Analysis of Welded Structures[M]. New York: Pergamon Press, 1980:88-111. |
| 备注/Memo: | 收稿日期: 2018?04?27. 宁波大学学报（理工版）网址: http://journallg.nbu.edu.cn/ 基金项目: 浙江省重点科技创新团队项目（2013TD21）. 第一作者: 陈沁恺（1993－）, 男, 浙江杭州人, 在读硕士研究生, 主要研究方向: 桥梁工程. E-mail: chenqk310@foxmail.com *通信作者: 柳俊哲（1964－）, 男, 黑龙江五常人, 教授, 主要研究方向: 混凝土耐久性. E-mail: junzheliu@163.com 宁波大学学报（理工版）网址：http://journallg.nbu.edu.cn/ |
